“How long should this have lasted?” is one of the most common questions we get on a service call, and it usually arrives with a note of suspicion — the sense that the machine gave up too early.
Sometimes it did. More often the appliance was running a decade’s worth of wear into six or seven years because of conditions nobody connected to it. Here’s what a realistic lifespan looks like for each type, and what actually moves the number.
Typical lifespan by appliance type
These are working ranges, not guarantees. A well-installed machine in a two-person household lands at the top of its range; the same model in a family of six with hard water lands at the bottom or below it.
| Appliance | Typical range | What usually ends it |
|---|---|---|
| Refrigerator | 10–13 years | Sealed system or compressor failure |
| Chest or upright freezer | 12–16 years | Compressor; often outlives everything else in the house |
| Dishwasher | 9–12 years | Pump, motor or tub corrosion |
| Washing machine | 10–13 years | Drum bearings or a cracked spider arm |
| Dryer | 10–14 years | Drum bearings, motor, or accumulated heat damage |
| Electric range | 13–16 years | Control board; elements are replaceable long before that |
| Built-in wall oven | 14–18 years | Control board or door hinge assembly |
| Cooktop | 13–16 years | Glass damage or element failure |
| Over-the-range microwave | 8–11 years | Magnetron or door interlock switches |
| Range hood | 12–16 years | Fan motor, usually after years of restricted airflow |
Two patterns are worth noticing. The simplest appliances last longest — a standalone freezer does one job with one moving part and routinely outlives a fridge by five years. And the shortest-lived items are the ones packed with electronics in a hot, greasy position, which is why over-the-range microwaves sit at the bottom of the list.
What actually shortens an appliance’s life
Almost none of it is brand. These five factors explain most of the gap between a machine that reaches its range and one that doesn’t.
1. Installation
The single biggest one, and the least suspected. An unlevel washer sends every spin cycle’s force through its bearings. A dryer on a crushed or over-long vent duct runs hotter and longer than it was designed to. A fridge with no clearance behind it never lets its compressor rest.
None of these look like faults. They just quietly consume years. If you’ve never checked, the signs that an appliance was installed wrong are worth ten minutes of your time.
2. Water quality
Every time a dishwasher or washing machine heats water, hard water leaves mineral deposits behind. Scale builds on heating elements until they have to run longer and hotter to reach the same temperature, narrows inlet valve screens, and coats the inside of pumps.
On a private well outside the city, this runs several times faster than it does on Winnipeg’s municipal supply — which is why two identical dishwashers of the same age can be in completely different condition.
3. Load and frequency
A washer rated for a certain capacity, run consistently above it, wears its suspension and bearings at a multiple of the normal rate. A dishwasher run twice a day ages roughly twice as fast as one run every other day. This is simple arithmetic, but it’s the reason a “ten-year” appliance in a busy household is genuinely finished at six.
4. Heat and airflow
Every appliance that makes heat needs somewhere to put it. Dryer vents, fridge condenser coils, range hood ducts, the clearance gaps around a built-in oven — all of them exist so heat can leave. Block any of them and the appliance compensates by working harder, which is exactly what wears it out. A dryer on a clogged vent is the clearest example: clothes that won’t dry properly are usually the duct, and the machine is paying for it the whole time.
5. Deferred small repairs
A worn door seal, a loose drum belt, a filter nobody clears. Individually trivial, and each one makes a bigger component work harder. Most of the failures we see at year seven started as something that cost very little to fix at year four. We cover this pattern in more depth in why appliances break down sooner than expected.
Signs an appliance is near the end of its range
These don’t mean the machine is finished. They mean it’s telling you something about where it is in its life.
- Cycles getting noticeably longer without any change in what you’re putting in
- A second repair on a different major component within a year of the first
- Rising electricity use with nothing else in the house changing
- Rust or corrosion on a tub or cabinet interior — structural rather than cosmetic
- Intermittent faults that clear on a reset and come back, which usually points at a control board
- Noise that changes character — a new grinding or rumbling rather than the usual sounds, as with a washer that shakes or walks across the floor
What we see in Winnipeg homes
A few patterns show up often enough here that they’re worth naming.
Freezers in unheated garages are a special case. Not every freezer is rated to run in a cold space, and a standard model in a Manitoba garage spends part of the winter with its compressor switched off by its own thermostat. In summer it has the opposite problem — a garage freezer struggling in a heat wave is working far harder than one indoors. Both ends of the year take time off its life.
Fridges fail at the sealed system more often than people expect. It’s the one repair where age genuinely matters, because a sealed system failure on a twelve-year-old unit is a different proposition from the same fault at year four. If your fridge section is warm while the freezer is fine, that’s usually a circulation problem rather than a dying compressor — worth knowing before you assume the worst.
Control boards are the modern limiting factor. Mechanical parts on a range or a wall oven will keep going for fifteen years. The electronics increasingly don’t, and that’s shifted where the end of life actually falls on cooking appliances.
Washers and dryers bought as a pair rarely fail as a pair. Dryers generally outlast washers, because a washer handles water, weight and spin forces while a dryer mostly handles heat and rotation.
What this means when something does break
Knowing where an appliance sits in its range is one input, not an answer. The other two are whether parts are still available for that model, and whether the failed component is a wear item like a pump, belt or element, or a core assembly like a sealed system or main control board.
That second question has changed in the last two years. Canada’s repair rules shifted in 2024, and access to parts and diagnostics is better than it was — we go through what actually changed in our guide to right to repair in Canada and what it means for your appliance.
If you’re trying to work out whether a specific machine is worth fixing, the model number and the symptom are usually enough for us to tell you over the phone. Our service pricing is published so you can weigh it against what you already know.
Frequently asked questions
How long should a refrigerator last?
Ten to thirteen years is the usual range. Clearance behind the unit, clean condenser coils and a door seal that still grips are what decide whether yours lands at the top or the bottom of it.
Which appliance lasts the longest?
A standalone freezer, typically twelve to sixteen years. It does one job, has minimal electronics, and opens far less often than a fridge. Built-in wall ovens come close for the same reason — mechanically simple, lightly used compared with a cooktop.
Which lasts the shortest?
Over-the-range microwaves, usually eight to eleven years. They combine electronics with a position directly above a cooking surface, which means constant heat and grease.
Do appliances really not last as long as they used to?
Partly true, and the reason matters. Mechanical components are generally as durable as ever. What's changed is that appliances now rely on control boards and sensors, which fail differently — suddenly, rather than by gradual wear — and often set the end of life before anything mechanical wears out.
Does brand make much difference?
Less than installation, water quality and load. We see the same brands last a long time in one home and fail early in another, and the difference is almost always conditions rather than badge.
My appliance is past its range but still working. Should I replace it?
No. Age alone isn't a reason to replace a machine that's doing its job. The range tells you what to expect, not when to act — plenty of appliances run well past the top of theirs.
Can regular maintenance actually extend the life?
Meaningfully, yes. Clearing a dryer vent, rinsing a dishwasher filter, vacuuming fridge coils and keeping a machine level are the four that make the biggest difference, and all four address the things that force an appliance to work harder than it should.
Do you work on all of these?
Yes — our appliance repair services cover every type in the table above, including refrigerator repair, washer repair, dishwasher repair and oven repair across Winnipeg.